Digital Motor Protection Relay

The MPR 2000 monitors three phase & ground currents, voltages, and temperature inputs to provide one of the most comprehensive motor protectionpackages available. Wth up to 10 temperature sensors, the MPR 2000 monitors as many as 39 programmable protective functions. It is ideal for high voltage motors, large low voltage motors, and applications where full protection and advanced warning is crucial, such as in the process and chemical industries.

MPC 2000 Digital Motor Protection and Control Relay

Similar to the MPR 2000 except that it also incorporates advancedcontrol capabilities for all types of starting methods, including softstarters and variable frequency drives.
The MPC 2000 has been specifically designed for integration into motor management systems in chemical, petrochemical and other process systems.

Motor Protection And Control

1. Max start time    2. Too many starts    3. Undercurrent pre-alarm    4. Undercurrent trip    5. Load increase    6. Stall protection    7. Short circuit    8. Overload    9. Earth Fault pre-alarm 10. Earth Fault trip 11. Unbalance current alarm 12. Unbalance current trip 13. Thermal pre-alarm 14. Thermal trip 15. Under-voltage 16. Over-voltage pre-alarm 17. Over-voltage trip 18. Phase loss 19. Phase sequence 20. Temp. 1 Pre-alarm and trip (separate setting is available for temp sensor trip) 21. Temp. 2 Pre-alarm and trip 22. Temp. 3 Pre-alarm and trip 23. Temp. 4 Pre-alarm and trip 24. Temp. 5 Pre-alarm and trip 25. Temp. 6 Pre-alarm and trip 26. Temp. 7 Pre-alarm and trip 27. Temp. 8 Pre-alarm and trip 28. Temp. 9 Pre-alarm and trip 29. Temp. 10 Pre-alarm and trip Each protection can be designated as:      * Trip (or Trip Fail-safe)      * Alarm Fail-safe      * Auto Reset      * Panel Reset      * Comm. Reset

Discrete Logic Inputs (MPC 2000 Only): * Local Start A/B * Local/Remote * PLC Reset * Speed Switch * Isolator * External Faults 1,2,3 * Contactor A/B Aux Relay * Local Stop * PLC/Serial Port * PLC Control * Plant Interlock * Contactor A/B Status Communications Full access through : RS485 with Modbus protocol True R.M.S. Measurements * Voltage, Current, and Resistance at sampling rate of 0.5msec * Available with 10 RTDs or 3 Thermistors and 2 RTD's Outputs - 4 Relays * Programmable for Overload, KWHR (energy) Pulse Initiator, or Slave for Alarm * Earth Fault * Alarm (Fail Safe) * Trip (Fail Safe) Displays - LCD Measured data :     Voltage - phase to phase     Voltage - phase to neutral     Current each phase     Earth fault current     Resistance each RTD/Thermistor     Power     Power Factor Calculated data :     Motor current in % of FLC     Thermal capacity     Time to trip     Time to start (after fault)     Unbalanced current Statistical data :     Total run time     Total number of starts     Total number of trips     Last start time period     Last start current peak     Energy Fault data :     Last trip     Last alarm     Trip current each phase     Trip earth fault current     Trip voltage (each phase)

Displays - LED's (MPR) * On * Stopped * Starting * Running * O/L Trip * E/F Trip * Alarm * Trip * Internal Failure Displays - LED's (MPC) * On * Stopped * Starting * Running * Contactor A * Contactor B * Alarm * Trip * Internal Failure

Typical Applications * High voltage and large low voltage motors * Motors in the Process Industry * Critical motors requiring special protection and/or supervision